![]() ![]() Once your sure you have your marks where you want them glue the 4″ PVC pipe into the 3-way tee. Once its lined up mark it with a marker so you will know where to set it when gluing. ![]() Place the 4″ PVC pipe into the 3-tee and line up the 45 degree cut so its facing the front of the feeder. Step 6. Next glue the 2″ pipe into the 2″ adapter. ![]() I found this length filled the feeder without spilling over. Next measure 4-1/4″ of the 2 inch pipe and cut it at a 45 degree angle like the pictures below. I set it in right where the cap starts to round off see the picture below. Next glue the three inch cap into the 4inch PVC pipe. Once you finish the steps in the link below come back here and continue with step 4.ĭIY Chicken Feed Indicator for PVC Chicken Feeder If you would like to add a flag indicator to this feeder so you will know when to add feed to it go to the link below before continuing on with step 4. I forgot to ake a picture of this step but you can see it in the picture below on the bottom right. Next thread the 2″ male adapter into the top of the 3 inch cap. Be careful not to make the hole to big or you will have to buy a new cap and start over. The 2-1/8″ hole is slightly to small for the 2″ male adapter to fit so you will have to file it or use a dremel until you get the right size for it to thread in. Step 3. Drill a 2-1/8″ hole into the center of the 3 inch PVC cap with your hole saw. Step 2. Glue the 4″ PVC DWV Street Spigot x FIPT Female Adapter to the bottom of the 3-way tee like the picture below. NOTE: At first I decided to mark it at the first seam but then changed my mind and cut it at the second seam it looked cleaner. Step 1. Mark out your 3-way tee, and cut off the lower half with a hack saw like the picture below. 1 – 2″ PVC pipe 2 foot length (only ended up needing less than 5 inches)ġ – 4″ PVC DWV Street Spigot x FIPT Female Adapter ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |